The Effect of Fuel Composition on Atmospheric Aerosol Due to Auto Exhaust

Aerosols attributable to automobile exhaust can be classified as two types—primary aerosol (initially present in the exhaust) and secondary aerosol (generated photochemically from hydrocarbons and nitrogen oxides in the exhaust). In this study, investigation was made of possible effects of motor-fuel composition on the formation of these aerosols. Secondary aerosol, of principal interest in this work, was produced by irradiating auto exhaust in Battelle-Columbus’ 610 ft³ environmental chamber. A limited number of determinations of primary aerosol in diluted auto exhaust was made at the exit of a 36 ft dilution runnel. Determination of both primary and secondary aerosol was based on light-scattering measurements.

Exhaust was generated with seven full-boiling motor gasolines, both leaded and nonleaded, in a 1967 Chevrolet which was not equipped with exhaust-emission control devices. Changes in fuel composition produced a maximum factor of three difference in light scattering due to primary aerosol. Aerosol yields, for consecutive driving cycles on the same fuel, vary considerably; as a result, ranking the fuels on the basis of average primary aerosol yield was not very meaningful. In addition to fuel composition, the more important independent variables are initial SO₂ concentration, relative humidity and initial hydrocarbon concentration. Statistical analysis of the data indicates that the seven test fuels can be divided into two arbitrary groups with regard to secondary aerosol-forming potential. The fuels in the lower light-scattering group had aromatic contents of 15 and 21%, while those in the higher light-scattering group had aromatic contents of 25, 48, and 55%. Although the fuels can be grouped on the basis of a compositional factor, the grouping of fuels with aromatic content ranging from 25 to 55% indicates that this compositional factor cannot be equated simply with aromatic content. In an associated study of the aerosol-forming potential of individual hydrocarbons prominent in auto exhaust, it was observed that aromatics produce substantially more photochemical aerosol than olefins and paraffins. However, experiments with binar/hydrocarbon mixtures containing aromatjcs, as well as in these exhaust experiments, a strong dependence of aerosol yield on the aromatic components is is not observed. Thus, the data indicate that the dependence of secondary aerosol formation on fuel factors is a complex one and cannot be predicted solely on the basis of a sirigle hydrocarbon component reactivity scale.

The two types of automobile aerosol did not have the same dependence on fuel, composition. The variation in total light scattering attributable to primary plus secondary aerosol was less than that due to either component alone. It therefore was concluded that the light scattering due to automobile exhaust emissions in these experiments was not significantly affected by changing fuel composition.     

The Removal of Particulate Matter from Fluid Bed Catalytic Cracking Unit Stack Gases

The application of a high-efficiency centrifugal type of separator to fluid bed catalytic cracking units is described in which most of the catalyst particles often lost to the atmosphere are concentrated into a small part of the stack gas (2%). A further separation can then be made on this small stream by an auxiliary separator which further concentrates the catalyst particle into 0.1% of the initia stream. Performance of the main and auxiliary separators are such as to reduce the loss of catalyst particles in the stack gas from 800 ppm to less than 60 ppm in a typical unit. Large amounts of power can be recovered by application of expander turbines to catalytic cracking plants employing this system of separation.     

Garnering input for recycling communication strategies at a Big Ten University

With increasing environmental challenges confronting our planet, colleges and universities are trying different approaches for minimizing their adverse environmental impacts. Among the approaches being used to revitalize campus sustainability efforts, new waste management strategies have included attempts to improve campus-recycling programs. This paper presents select findings from a comprehensive study at a large, Tier I university aimed at, among other things, informing university administration and decision makers working on the planning and implementation of a new campus-wide recycling facility and program. The researchers used a mixed-method approach to help them develop an understanding of the campus community's (1) perceived barriers to recycling, (2) recycling knowledge, (3) program preferences, and (4) environmental attitudes. The results from a web-based survey (n = 3896, RR1 = 24.9%) suggest, communication efforts for recycling programming should focus more on messages concerning what, how, and where to recycle rather than messages on why to recycle. Furthermore, the results suggest recycling-related publicity approaches should differentiate their mode and content for different segments of the community.     

Effect of Refractory on the Thermal Stability of SF6

The thermal decomposition of SF₆ is known to be oxygen-independent. Nevertheless, because of its high stability, the use of SF6 as a "conservative" surrogate in incinerator performance evaluation has been advocated and researched. This paper shows that refractory decreases markedly the stability of SF₆. The resulting increase in SF₆ decomposition was from 0 percent to 95 percent at 900°C, and the temperatures at which 90-99 percent decomposition occurred were lowered by 300-150°C. Refractory also decreased the stability of CCl₄ and C₂Cl₄, but to a lesser extent. The difference between the decompositions of C₂Cl₄ and SF₆ was reduced from several orders of magnitude to a factor of 2-4. Such a drastic and adverse change in relative stability could render SF₆ unsuitable as a "conservative" surrogate. The requirements for a "conservative" surrogate and the need for caution in its use are discussed, and further research areas are indicated.     

Application of a permethrin immunosorbent assay method to residential soil and dust samples

A low-cost, high throughput bioanalytical screening method was developed for monitoring cis/trans-permethrin in dust and soil samples. The method consisted of a simple sample preparation procedure [sonication with dichloromethane followed by a solvent exchange into methanol:water (1:1)] with bioanalytical detection using a magnetic particle enzyme-linked immunosorbent assay (ELISA). Quantitative recoveries (83–126 %) of cis/trans-permethrin were obtained for spiked soil and dust samples. The percent difference of duplicate ELISA analyses was within ± 20 % for standards and ± 35 % for samples. Similar sample preparation procedures were used for the conventional gas chromatography/mass spectrometry (GC/MS) analysis except that additional cleanup steps were required. Recoveries of cis/trans-permethrin ranged from 81 to 108 % for spiked soil and dust samples by GC/MS. The ELISA-derived permethrin concentrations were highly correlated with the GC/MS-derived sum of cis/trans-permethrin concentrations with a correlation coefficient (r) of 0.986. The ELISA method provided a rapid qualitative screen for cis/trans-permethrin in soil and dust while providing a higher sample throughput with a lower cost as compared to the GC/MS method. The ELISA can be applied as a complementary, low-cost screening tool to prioritize and rank samples prior to instrumental analysis for exposure studies.     

Efficacy of recent state implementation plans for 8-hour ozone

The development of state implementation plans (SIPs) for attainment of criteria pollutant standards is an integral component of air quality management in the United States. However, the content and efficacy of SIPs have rarely been examined systematically. Here, 20 SIPs developed in response to the 1997 8-hr ozone standard are reviewed as case studies of attainment efforts at the state level. Comparison of observed and model predicted ozone concentrations shows the US Environmental Protection Agency (EPA) recommended modeled attainment test to be a somewhat conservative predictor of attainment. Among 12 SIPs for regions that sought attainment by 2009, the test correctly predicted attainment and nonattainment in four and five regions, respectively; in the other three regions, attainment was observed despite predictions of nonattainment. However weight-of-evidence determinations and deviations from the recommended modeled attainment test methodology led five of these SIPs to predict attainment that was not in fact observed by 2009; three of those regions achieved attainment in 2010. Ozone and NO2 concentrations declined across much of the United States during the period covered by the SIPs, with rates of improvement strongly correlated with the initial pollution levels and hence greatest in nonattainment regions. However at monitors with mid-range levels of ozone initially, rates of reduction were largely independent of the initial attainment status of the region. This is consistent with thefact that apart from California, the majority of ozone precursor reductions documented by SIPs resulted from federal measures rather than from state or local controls specific to the nonattainment regions.     

Biomonitoring of heavy metals in the feathers of House crow (Corvus splendens) from some metropolitans of Asia and Africa

Environmental Science and Pollution Research - Urban-dwelling birds can be useful biomonitors to assess the impact of the urbanisation on both public and wildlife health. Widely distributed urban...     

Assessment of potential health risk for inhabitants living near a former lead smelter. Part 1: metal concentrations in soils, agricultural crops, and homegrown vegetables

Soil contamination by metals engenders important environmental and health problems in northern France where a smelter (Metaleurop Nord) was in activity for more than a century. This study aims to look at the long-term effects of the smelter after its closedown by combining data on the degree of soil contamination and the quality of the crops grown (agricultural crops and homegrown vegetables) in these soils for a better assessment of the local population’s exposure to Cd, Pb, and Zn. Seven years after the Metaleurop Nord closedown, (1) the agricultural and urban topsoils were strongly contaminated by Cd, Pb, and Zn; (2) the kitchen garden topsoils were even more polluted than the agricultural soils, with great variability in metal concentrations within the gardens studied; (3) a high proportion of the agricultural crops for foodstuffs did not conform with the European legislation; (4) for feedstuffs, most samples did not exceed the Cd and Pb legislation limits, indicating that feedstuffs may be an opportunity for most agricultural produce; and (5) a high proportion of the vegetables produced in the kitchen gardens did not conform with the European foodstuff legislation. The high contamination level of the soils studied continues to be a risk for the environment and the population’s health. A further investigation (part 2) assesses the associated potential health risk for local inhabitants through consumption of homegrown vegetables and ingestion of soil particles by estimating the site-specific human health assessment criteria for Cd and Pb.     

Adverse birth outcomes in the vicinity of industrial installations in Spain 2004–2008

Industrial activity is one of the main sources of ambient pollution in developed countries. However, research analyzing its effect on birth outcomes is inconclusive. We analyzed the association between proximity of mother’s municipality of residence to industries from 24 different activity groups and risk of very (VPTB) and moderate (MPTB) preterm birth, very (VLBW) and moderate (MLBW) low birth weight, and small for gestational age (SGA) in Spain, 2004–2008. An ecological study was defined, and a “near vs. far” analysis (3.5 km threshold) was carried out using Hierarchical Bayesian models implemented via Integrated Nested Laplace Approximation. VPTB risk was higher for mothers living near pharmaceutical companies. Proximity to galvanization and hazardous waste management industries increased the risk of MPTB. Risk of VLBW was higher for mothers residing near pharmaceutical and non-hazardous or animal waste management industries. For MLBW many associations were found, being notable the proximity to mining, biocides and animal waste management plants. The strongest association for SGA was found with proximity to management animal waste plants. These results highlight the importance of further research on the relationship between proximity to industrial sites and the occurrence of adverse birth outcomes especially for the case of pharmaceutical and animal waste management activities.